CIB Slider Installation:

This installation method works for all compatible plates using Universal and Pro Sliders. Pro Sliders are only compatible with Wide Truck builds.

TOOLS FOR REMOVING SKATE HARDWARE:
SPANNER/SOCKET WRENCH/SCREWDRIVER

1 x DRILL & 5.5 MM DRILL BIT
1 x PERMANENT MARKER
1 x HACKSAW/GRINDER/RECIPROCATING SAW
1 x METAL FILE (OPTIONAL)

A work bench will come in handy.

INSTRUCTIONS

 

  • First start by removing the laces and innersoles.
  • Next remove trucks from plate.
  • Undo existing mounting hardware and remove plate and hardware from boot.
  • Now lining your CIB Sliders up with the center of your king pins mark the holes with your permanent marker. FIG.1

CIB-slider-installation-FIG1

  • With your sliders held over the edge of a work bench you can carefully drill the holes.
  • Make sure to drill exactly on your marks. FIG.2

CIB-slider-installation-FIG2

  • Now you’re ready for reassembly.
  • Reusing any existing boot washers install all new CIB mounting hardware.
  • Be sure to use the longer bolts on the back end (larger heeled boots may require longer mounting hardware).
  • Seat plate and your CIB Slider and secure all bolts with a flat washers and nylon nuts.
  • Last and most important is trimming the excess bolt length!
  • This will give you wheel clearance and help reduce any wheel bite.
  • Using your hacksaw/grinder/reciprocating saw cut excess bolt flush with the nut.
  • Take extra care not to cut into your plate or sliders. FIG.3

CIB-slider-installation-FIG3

  • Reassemble trucks and wheels.
  • Now you’re ready to shred!
  • Taking it to the coping.

WARNING: Chicks in Bowls takes no accountability for any damage done to plates, wheels or boots during installation or use. Wheel bite may occur if mounting hardware is not trimmed properly or use of wheels larger than 58mm. Tighten trucks to reduce risk. Longer rear mounting hardware is required for artistic/figure skates. Chicks in Bowls are not responsible for damage to wheels due to improper installation. CIB Sliders are designed to be used for aggressive quad skating. Wear and tear will occur. Use responsibly. Do not use while intoxicated. Use at your own risk.